Filter
Top Products
Basic Operations 78
XXXXXXXXXXXXXXXXXX: Media settings are based on those stored in the printer
in media settings bank No. 1.
Media settings banks can store a variety of settings for different media based on the
options selected in the Heater Temperature, Media Suction, Head Alignment, and other
menus. Up to 30 combinations of settings can be stored by assigning them to banks No.
1 to 30.
Using custom settings is strongly recommended to assure that the platen gap, media
feed adjustment, and head alignment are consistent and correct for each type of media.
See “Saving Settings” on page 93.
1. Select an option.
To print at current settings:
Use the d/u buttons to select Keep Settings Above and press the Z button.
Proceed to Step 6.
To change settings:
Use the d/u buttons to select Change Settings and press the Z button.
2. Select the items you want to change and press the Z button.
3. Select the desired option and press the Z button.
4. Press the y button to display the dialog shown in Step 2 and then press the y button
again.
5. After confirming that the settings are correct, use the d/u buttons to select Keep
Settings Above and press the Z button.
6. If On is selected for Remaining Setup, you will be prompted to enter the length of the
current media. Use the d/u buttons to choose a length between 5.0 and 99.5 m (15 and
300 feet) and press the Z button. You can set in 0.5 m increments. If the display is in
feet, lengths are given in increments of 1 foot.