Filter
Top Products
Basic Operations 90
Removing the Take-up Roll
The procedure for removing media varies depending on whether you are using the
installed auto take-up reel unit or the optional auto take-up reel unit for heavy media.
Follow the steps below when using the supplied auto take-up reel unit.
1. Cut the media and roll the cut end onto the take-up reel. See “Cutting Media” on page
80.
2. To prevent the media from sliding off the roll, support the roll at its left end.
3. Loosen the left roll core holder fixing screw and remove the roll core holder from the roll.
4. Lower the roll onto the roll support.
5. To prevent the media from sliding off the roll, support the roll at its right end.
c
Caution:
Because the media is heavy, it should not be carried by one person. When loading or
removing the media, use at least two persons.
Follow the instructions in the manual when loading media or roll cores or removing media
from the take-up roll.
Dropping media, roll cores, or take-up rolls could result in injury.