Filter
Top Products
Example print control for cut sheet
1) Enables
printing
stop due to slip paper-end.
2) Enables
ASB
for all status changes.
3) Receives ASB due to 2).
4) Selects slip printing.
5) Waits for slip paper to be selected.
ASB:
waits for slip paper selection
(ASB
4-0*)
to be “selected” (0). *Indicates bit 0
of the fourth byte of the ASB data. The
same rule applies correspondingly to the
following:
6) Waits for slip paper to be inserted.
ASB:
wait for cut sheet sensor (ASB
3-5)
to be “paper p”
(0).
7) To cancel the slip paper waiting state, send
DLE ENQ 3.
When canceled, the printer returns to
paper roll mode, and the 4 bytes of
ASB
are transmitted.
ASB: slip paper state
(ASB
4-l)
becomes
“not selected” (1).
8) Waits for the slip to
be
loaded.
ASB:
waits for the slip paper state
(ASB
4-l) to be “printable” (0).
9) Transmits each line of print data until
there is no data to be transmitted.
In this case,
ASB
is transmitted when the
paper has run out.
ASB:
slip paper state (ASB
4-l)
becomes
“not printable” (1).
Advances to step
10)
when all the data has
been sent.
10)
Ejects the slip paper.
4-10 Reference Information