Filter
Top Products
Operation, cont’d
CrossPoint 300 Matrix Switchers • Operation3-18
Muting and unmuting video and/or audio
Individual outputs can be muted or unmuted as follows:
Mutes are protected when front panel lock mode 2 is selected. You can view
the status of the output (muted or unmuted) in lock mode 2 but not change it
from the front panel.
1. Press the Esc button to clear any input LEDs, output LEDs, or control LEDs
that are lit.
2. Press and release the View button.
3. Select video, audio, or both to mute or unmute by pressing the RGBHV
button and/or the Audio button.
4. One at a time, press and hold the output button(s) for the desired output(s)
for approximately 2 seconds. The output LED(s) for the selected output(s)
blink to indicate the mute or return to their previous state to indicate the
unmute.
5. Press and release the View button to return to normal switcher operation.
• You can mute video and audio, video-only, or audio-only outputs.
Pressing and releasing the RGBHV button and the Audio button toggles
each selection on and off.
• When you enter View-only mode, the output LEDs turn on for all
outputs without ties.
• The video mute function mutes the R, G, and B planes only; the H and V
planes are still active.
• Mutes are saved to non-volatile memory. When power is removed and
restored, the mute settings are retained.
Example 5: Muting and unmuting an output
The following steps show an example in which several matrix switcher outputs are
muted and unmuted. The steps show the front panel indications that result from
your actions.
1. Press and release the Esc button (figure 3-28).
ENTER PRESET VIEW ESC
CONTROL
P
ress the Esc button to clear all selections.
The LED
blinks once
.
Figure 3-28 — Clear all selections
2. Press and release the View button to enter View-only mode. The View LED
lights.