Filter
Top Products
ii CrossPoint 300 Matrix Switchers • Table of Contents
Table of Contents, cont’d
Setting the front panel locks (Executive modes) ........................................................... 3-34
Selecting Lock mode 2 or toggling between mode 2 and mode 0 ............................. 3-35
Selecting Lock mode 2 or toggling between mode 2 and mode 1 ............................. 3-35
Performing a system reset from the front panel ........................................................... 3-36
Selecting the rear panel Remote port protocol and baud rate .................................... 3-37
Rear Panel Operations .................................................................................................... 3-39
Performing a system reset from the rear panel ............................................................. 3-39
Performing a hard reset from the rear panel ................................................................ 3-40
Optimizing the Audio (HVA Switchers) ................................................................. 3-40
Troubleshooting ................................................................................................................ 3-41
General checks ................................................................................................................. 3-41
Plasma display S-video problem ...................................................................................... 3-41
Configuration Worksheets ........................................................................................... 3-42
Worksheet example 1: Entering system equipment ...................................................... 3-42
Worksheet example 2: Drawing ties ............................................................................... 3-43
Worksheet example 3: Test configuration ...................................................................... 3-44
Matrix Switchers Configuration worksheet ................................................................... 3-45
Chapter 4 • Programmer’s Guide ..................................................................................... 4-1
Serial Ports ............................................................................................................................. 4-2
Rear panel Remote port .................................................................................................... 4-2
Front panel Configuration port ........................................................................................ 4-3
Host-to-Switcher Instructions....................................................................................... 4-3
Switcher-Initiated Messages ......................................................................................... 4-4
Switcher Error Responses ............................................................................................... 4-5
Using the Command/Response Table ........................................................................ 4-5
Command/Response Table for SIS Commands ..................................................... 4-6
Symbol definitions ............................................................................................................. 4-6