Filter
Top Products
Upgrades and Troubleshooting, cont’d
Matrix 3200/6400 Series • Upgrades and Troubleshooting5-8
Matrix 6400 Audio Switcher Upgrade - Changing the
Matrix Size
Changing the matrix size of a Matrix 6400 Audio Switcher may require adding or
removing input and/or output audio circuit cards. Page 5-9 describes the
procedure for determining the required number of input and output cards for the
desired matrix size and which connectors the cards should be plugged into. The
following procedure describes how to change the matrix size.
1. See Page 5-12 “Software Procedure - Before and After a Hardware
Upgrade”. Do steps under “Before Hardware Changes” prior to making any
hardware changes.
To ignore step 1 and proceed with the hardware upgrade will require
considerable system reconfiguration time. It is highly recommended that you
not skip any step.
2. Turn OFF the AC power switch and unplug the AC power cord.
Installing or removing Audio cards with power on may damage the equipment.
3. Plug the audio cards in as required (see page 5-9).
4. Plug the AC power cord in and turn ON the AC power switch.
5. Do the steps under “After Hardware Changes” on Page 5-13.
6. Verify that the new matrix size is correctly identified by the software.
ANAHEIM, CA
MADE IN USA
A
C
P
O
W
E
R
IN
P
U
T
F
U
S
E
: 2
50
V
5.0
A
TT
100-240V 0.5A MAX 50/60Hz
DISCONNECT POWER CORD BEFORE SERVICING
BME
ADDRESS
4
IN
O
U
T
BME COMM.
MKP COMM.
A
B
C
D
E
A
B
C
D
E
Align with plastic guides
IN
1 - 8
IN
9 - 16
IN
17 - 24
IN
25 - 32
IN
33 - 40
IN
41 - 48
IN
49 - 56
57 - 64
OUT
1 - 8
OUT
9 - 16
OUT
17 - 24
OUT
25 - 32
OUT
33 - 40
OUT
41 - 48
OUT
49 - 56
OUT
57 - 64
INPUTS
OUTPUTS
IN
Figure 5-7.A Inserting an audio card into slot 57-64.