Filter
Top Products
Extron • System 4
xi
Switcher Series • User’s Manual
Chapter 3 • Using the System 4
xi
Front Panel
Menu #6 is used to set up composite or separate horizontal and vertical sync for
line-doubled/quadrupled images. Follow the numbers in the diagram and
continue.
❶ Press to get the Menu Select Options (Menu #0).
❷ Press or to get
Menu #6 (LD Sync
CFG).
❸ Press to select
this menu. There are
four functions in this
menu as displayed
from the left selection
point. They are listed in
the diagram. Use to
move between the two
selection points, and
then use or to
show the choices, and
leave your choice
displayed before going
to the next function.
❹ From the left selection
point, press or to
choose one of the four
functions.
❺ Press to step to the
second selection point
and press or to
change the selection
for that function. If the
display already shows
what you want, leave it
and go on. The
choices made for this
example are circled.
❹ Press to step back
to the left selection
point. Repeat steps ❹
and ❺ until you have
made all of your
changes to this menu.
❻ Press to save
these settings and
press to go to
Menu #0. From there
you may step to
another menu and start
your next setup
procedure, or exit.
➐ Press to exit Menu #0 and go to the Default Menu.
Figure 3-4. Example: Configuring System 4 Output Sync for Line Doubled/Quadrupled Sources
_______ A detailed explanation of each menu follows, beginning with Menu #0 .
3-5
1
MENU SELECT
7.LD CFG
MENU SELECT
9.SWITCH SLAVE
MENU SELECT
8.INFORMATION
MENU SELECT
1.VID MODE CFG
MENU SELECT
3.HOST BAUDRATE
MENU SELECT
4.RGB DELAY
MENU SELECT
5.SLAVE CFG
Change Entry Point
Change Selection
Accept/Save Selection
Exit to Menu 0
MENU SELECT
0.EXIT
Default
Screen
MENU SELECT
2.AUD LEVEL CFG
Go to
Men 0
After 2-3
second
delay
Displayed information
depends upon video
type, audio level and
breakaway setting.
Go to
Menu 9
SYSTEM 4LD
EXTRON V3.11
->VID 01 RGBS
->AUD 01 +00dB
Power Up
Display
MENU SELECT
6. LD SYNC CFG
7
2
3 6
4 Select function and move cursor
4 functions, 2 choices each
Make selection
LD SYNC CFG
>H/HVOUT=>CSYNC
4
4
4
4
5
5
5
5
5
a - Select H/HVOUT =
Select H Only
b - Select SERRA. =
Select PRESENT
c - Select HOUT POL =
Select NEG
d - Select VOUT POL =
Select NEG
*Only if configured
as a Slave switcher