Filter
Top Products
MPS Series • Installation
2-2
Installation
Mounting the Switcher
The MPS 112 and MPS 112CS are housed in 1U high, 17.4" wide metal enclosures
that are rack- or desk-mountable. The appropriate rack/desk mounting kit
(#70-077-03) is included with the switchers. The switchers may also be surface-
mounted under a table, desk, or podium, or on a wall, using an optional Extron 1U
enclosure under-desk mounting kit (#70-222-01).
Rack mounting
Rack mount the switcher as follows:
1. Attach the supplied rack mounting brackets to the switcher with the eight
provided #8 machine screws (figure 2-1).
2. Insert the switcher into the rack, align the holes in the mounting bracket with
those of the rack.
3. Secure the switcher to the rack using the supplied machine screws.
Table or wall mounting
The table/wall mounting brackets extend approximately 1/4" (6.4 mm) above the
top surface of the switcher enclosure. This design allows for an air space between
the enclosure and the surface to which it is mounted. Table or wall mount the
switcher as follows:
1. Attach the table/wall mounting brackets to the switcher with the eight
provided #8 machine screws (figure 2-1).
2. Hold the switcher with the attached brackets against the underside of the
table or other furniture, or against the wall. Mark the location of the screw
holes of the bracket on the mounting surface.
3. Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.4 mm) deep in the mounting
surface at the marked screw locations.
4. Insert #8 wood screws into the four pilot holes. Tighten each screw into the
mounting surface until just less than 1/4" of the screw’s head protrudes.
Figure 2-1 — Mounting the MPS switcher
#8 Screw (4 Plcs)
Each Side
Mounting Screws (2 Plcs)
Each Side
or
Supplied Rack Mounting Bracket
Optional Furniture Mounting Bracket
50/60 Hz
100-240V 0.5A MAX
(VIDEO)
M
P
S
1
1
2
P
R
O
G
O
U
T
O
U
T
43
2
1
O
U
T
O
U
T
O
U
T
O
U
T
R
S
-
2
3
2
43
2
2
1
1
2
1
4
3
4
3
L
R
O
U
T
4
3
2
1
(S-VIDEO)
AUDIO
VIDEO VGA
(VGA)
MIC IN
S-VIDEO