Filter
Top Products
R
ESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0)
122
Replacing the Printhead Harness Assembly (830162-00) (cont.)
Step Procedure
13 Remove the Screw (130972) that secures the Headlift Sensor Switch to the
Front Plate/Print Assembly Sideplate (830302).
14 Lift the Headlift Sensor Switch out of the printer.
15 Cut the Tie Wrap (140013) that attaches the Head Harness Assembly to the
Back Plate/Print Assembly Sideplate (830303).
16 Remove the Rear Pivot Cover.
17 Refer to drawing 8301XX to remove the Screw (130971), Screw (130939),
Washer (130949), and Cable Clamp (140013) from the Power Circuit Board
Power (drawing 830179).
18 Lift up on the Backplate; guide the Power Circuit Board over the lip of the printer
baseplate.
19 Locate the cable connections.
20 Place a small piece of tape on each cable; write the cable connection location on
that tape.
21 Disconnect the cable connections.
22 Take the Printhead Harness Assembly from the printer.