Filter
Top Products
R
ESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0)
140
Installing the New Magnetic Head Assembly
Step Procedure
1 Position the new magnetic head in the Access Plate area.
2 Work the cable connector through the opening to the baseplate area.
3 Connect the cable connector at J18 on the Print Circuit Board.
4 Attach the Print Circuit Board to the baseplate.
5 Replace the Rear Pivot Cover.
6 Turn the printer upside down.
7 Position the two Magnetic Head Spacers if using 30 mil thick cards; they can
be removed for 10 mil thick cards.
8 Remove the plastic cover from the Magnetic Head Assembly.
9 Position the Magnetic Head Assembly in place.
10 Secure it with the two Screws.