Filter
Top Products
R
ESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0)
97
Making Mechanical Adjustments to the Printhead (continued)
Symptom: Printed image has a dark band across the card, about 1/8 in. (3mm) from the
card leading edge.
Solution: The ribbon deflector on the Printhead may be too low.
Step Procedure
1 Open the Top Cover.
2 Loosen the two Screws (Item 1, below) that hold the ribbon deflector (Item 2,
below) in place.
3 Locate the adjustment screws for the ribbon deflector (Item 3, below).
4 Turn each adjustment screw 1/8-turn clockwise. Turn each screw the same
amount.
5 Tighten the screws loosened in step 2. Do not overtighten them.
6 Close the Top Cover.
7 Print a sample card.
8 Repeat steps 1-7 until the image is correct.