Filter
Top Products
R
ESTRICTED USE ONLY Fargo Electronics, Inc.
Persona C10/M10 ID Card Printer Service Manual (Rev. 4.0)
92
Diagnostic Tools – Start by running a Self-Test
Perform a self test after initial setup of the printer, after a calibration procedure has been
conducted, or after a part has been replaced. The self test checks for proper operation of the
printer. The procedure described below is an alternative to method found in the User’s
Manual. A sample of the self test print is shown below.
Step Procedure
1 Unplug the power cord from the rear panel.
2 Install a full-color ribbon and cards in the Card Printer.
3 Press and hold the on-line button; plug the power cord back into the rear panel
connection while holding down the on-line button.
4 Release the on-line button once the printer begins to cycle the drive motor.