Filter
Top Products
FS-8700-41 Simplex 4100 Driver Manual Page 44 of 58
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldserver.com
Tel: (408) 262-2299 Fax: (408) 262-2296 Toll_Free: 888-509-1970 email: support@fieldserver.com
Appendix C. Error Messages
Error Message Troubleshooting Tip
Sim4100:#1 <card><point><sub>
invalid for ack. Read manual.
The card-point-sub is being used to derive an array
offset. The calculation requires division by the point
& the sub and one or both of these values are zero.
Sim4100:#2 RTS has been asserted for
too long. Extend timer, check cable
uses RTS/CTS or reconfig 4100 device
to suppress hardware handshaking
If RTS-CTS handshaking has been used then this
message is produced if the driver finds that the
RTS has been asserted by the slave device for too
long. The timeout is hard coded at 2.0s.
Sim4100:#3 sim4100_chan_init() Init
with null chan.
Requires support from FieldServer Technologies.
Sim4100:#4 Unknown sim4100_func in
csv <nnn>
The driver has found a value for a sim4100_func
keyword that it does not recognize. Check the CSV
file and read Appendix A.2 of this manual for a list
of legal keywords.
Sim4100:#5 Use Ackall function.
The sim4100_func keyword has been assigned the
value 'ack' but a card-point-sub has not been
specified. It would be better to use the ackall
function instead.
Sim4100:#6 ack/ackall/seta/setd must
be a write.
You cannot use the rdbc function with these
keywords. Use a wrbc instead.
Sim4100:#7 disable/restart/list not
implemented
You cannot use these keywords at the present
time. If you require one of these functions
implemented call FieldServer Technologies.
Sim4100:#8 Func=Clistall/Clist, wrbc
not allowed
These keywords must be used with a rdbc instead.
Sim4100:#9 Write ack was not
expected.
Please report this error to FieldServer
Technologies.
Sim4100:#10 Invalid point status
<s><v><a>=(Hex)<%x><%x><%x>
<%c><%c><%c>
Please report his message to FieldServer
Technologies noting the values in braces.
Sim4100:#11. Error. Array too short.
rqd= %d( max= %d) act= %d.
MapDesc= <%s> Data Abandoned!
Subsequent msgs suppressed!
Check the CSV file Data Array lengths.
Sim4100:#12 Error. Incoming data is being abandoned.
Subsequent message supressed!
Check the CSV file; there was no matching Map
Descriptor for a message.
Sim4100:#13 FYI. Login Function not
Implemented.
Please contact FieldServer Technologies if you
would like this feature implemented.