Filter
Top Products
FS-8700-41 Simplex 4100 Driver Manual Page 49 of 58
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldserver.com
Tel: (408) 262-2299 Fax: (408) 262-2296 Toll_Free: 888-509-1970 email: support@fieldserver.com
Appendix D. Pseudo Points
It is beyond the scope of the driver manual to describe the full functionality of the Simplex
Panels. However, we have found it useful to provide the following data to customers. The
following information is not maintained and updated therefore you should use it for reference
only and should always consult with the vendor of your Simplex system before implementing
any project decisions or actions based on the information provided in this section.
Pseudo points are points that report states or attributes based on how the Simplex system has
been installed, configured and programmed. They are often programmed to groups, devices,
zones or other logic groupings. For example, a pseudo point may be programmed to report if
and only if more than one sensor in a particular area is reporting smoke.
Every Simplex system has a number of default pseudo points programmed into the firmware
supplied with the panel. These default points depend only on the firmware revision number and
are generally unaffected by the configuration programmed for a particular site.
Although the 4100 card number can range from 0-250 in theory, only the following ranges are
presently used in the system:
Card address Card type
0-119 Physical (Hardware) cards
128-143 Digital Pseudo cards
144-159 Analog Pseudo cards
160-175 List Pseudo cards
Digital Pseudo’s: There are 250 fixed pseudo's in the 4020 panel and 511 in the 4100 and
4100U. The numbering sequence is simple, 128 starts the first block of 256 (0 to 255), so the
first point is 128-0-0, the second is 128-1-0, and so on. The next block starts at 129 and follows
the same sequence, then 130 and so on up to 143. In the 4100 the first user definable pseudo
is P-256, in the 4100U it's P-512.
P0 SYSTEM RESET KEY UTILITY 128-0-0
P1 ALARM SILENCE KEY UTILITY 128-1-0
P2 FRONT PANEL LAMPTEST CONTROL (ANNUNC. 0) UTILITY 128-2-0
P3 FIRE ALARM DETECT UTILITY 128-3-0
P4 GLOBAL ACKNOWLEDGE ENABLE UTILITY 128-4-0
P5 SET SERVICE PSEUDO VALUES UTILITY 128-5-0
P6 ALARM SILENCE UTILITY 128-6-0
P7 EXTRA CARD IN THE SYSTEM TROUBLE
128-7-0
P8 KEYPAD ACTIVE UTILITY 128-8-0
P9 SYSTEM OUT OF CQB'S TROUBLE
128-9-0
P10 CODED INPUT ACTIVE UTILITY 128-10-0
P11 UNACKNOWLEDGED FIRE ALARM EXISTS UTILITY 128-11-0
P12 UNACKNOWLEDGED SUPERVISORY EXISTS UTILITY 128-12-0
P13 UNACKNOWLEDGED TROUBLE EXISTS UTILITY 128-13-0
P14 SYSTEM DISABLED - PROGRAMMER DOWNLOAD TROUBLE
128-14-0
P15 CFIG RAM WRITE PROTECT MISSING (SW1-1) TROUBLE
128-15-0
P16 SMPL PROGRAM 0 - SYSTEM DEFAULT UTILITY 128-16-0