Filter
Top Products
Autotest
Saving Autotest Results
3
3-23
Saving Autotest Results
The test tool’s memory can store the results of 500 or more Autotests, depending
on the software version and test standard used. You can save the results from an
Autotest anytime after the Autotest is complete, but before another Autotest or a
Single Test is started.
To save Autotest results, proceed as follows:
1. After an Autotest is complete, press S. The test save screen appears, as
shown in Figure 3-8. Table 3-10 describes the items on the screen.
2. Use the appropriate editing keys to enter a cable identification name for the
test results you are saving.
To delete the character left of the cursor, press $Delete. To add
characters to the name, use the L R and D U keys to highlight characters in
the list, then enter the highlighted character in the cable identification by
pressing E. To edit characters in the middle of a name, use ! to
move the cursor into the name.
Model DSP-2000 allows you to increment or decrement an alphanumeric
character anywhere in the cable identification. Use ! to highlight the
desired character; then press @ INC or #DEC. To move the cursor
back to the right-most character, press ! until the cursor wraps back to
the right.
3. Press S to store the test results with the cable identification displayed. A
confirmation screen appears for about 2 seconds.