Filter
Top Products
NAT/Route mode installation Using the command line interface
FortiGate-800 Installation and Configuration Guide 45
3 Set the IP address and netmask of the external interface to the external IP address
and netmask that you recorded in Table 10 on page 42.
set system interface external mode static ip <IP_address>
<netmask>
Example
set system interface external mode
static
ip 204.23.1.5
255.255.255.0
To set the external interface to use DHCP, enter:
set system interface external mode dhcp connection enable
To set the external interface to use PPPoE, enter:
set system interface external mode pppoe
username
<user name>
password
<password>
connection
enable
Example
set system interface external mode pppoe username
user@domain.com password mypass connection enable
4 Optionally, set the IP address and netmask of the DMZ interface to the DMZ IP
address and netmask that you recorded in Table 12 on page 43. Enter:
set system interface dmz mode static ip <IP_address> <netmask>
Example
set system interface dmz mode static ip 10.10.10.2
255.255.255.0
5 Set the IP address and netmask of interfaces 1 to 4 to the IP addresses and netmasks
that you recorded in Table 12 on page 43.
set system interface <interface_name> mode static ip
<IP_address> <netmask>
Example
To set the IP address of interface 3 to 192.45.56.73 and netmask to 255.255.255.0,
enter
set system interface port3 mode
static
ip 192.45.56.73
255.255.255.0
6 Confirm that the addresses are correct. Enter:
get system interface
The CLI lists the IP address, netmask, and other settings for each of the FortiGate
interfaces.
7 Set the primary DNS server IP addresses. Enter
set system dns primary <IP address>
Example
set system dns primary 293.44.75.21
8 Optionally, set the secondary DNS server IP addresses. Enter
set system dns secondary <IP address>
Example
set system dns secondary 293.44.75.22