Filter
Top Products
80 Fortinet Inc.
Managing an HA cluster High availability
To monitor cluster interfaces
1 Connect to the cluster and log into the web-based manager.
2 Go to System > Config > HA.
3 In the Monitor on Interface section, select the names of the interfaces that you want to
monitor.
4 Select Apply.
The cluster synchronizes this configuration change to all cluster units.
Viewing the status of cluster members
The web-based manager lists the serial numbers of all the FortiGate units in the
cluster. The primary unit is identified as Local. For each cluster member, the list
includes the up time and status for that cluster member.
To view the status of each cluster member
1 Connect to the cluster and log into the web-based manager.
2 Go to System > Status > Cluster Members.
Figure 16: Example cluster members list
Monitoring cluster members
To monitor health information for each cluster member
1 Connect to the cluster and log into the web-based manager.
2 Go to System > Status > Monitor.
The cluster displays CPU, memory status, and hard disk status for each cluster
member. The primary unit is identified as Local and the other units in the cluster are
listed by serial number.
The display includes bar graphs of current CPU and memory usage as well as line
graphs of CPU and memory usage for the past minute.
For more information, see “Viewing CPU and memory status” on page 111.
Note: Only monitor interfaces that are connected to networks. You should not configure cluster
interface monitoring until the cluster is connected to your network.