Filter
Top Products
4-4 User’s Manual
Installing an Interface Expansion Board
With default settings, the printer automatically selects the active
emulation. To specify an emulation steadily, select the emulation
using the control panel. Use the Personality item of the Config menu.
Once you select the alternate emulation, the other menus change to
reflect the options and functions of the new emulation. Consult the
documentation supplied with the emulation card for the menu
functions and items. Procedures for working in the menus remain
the same as for the resident emulation.
The printer’s standard interface is parallel. The available optional
interfaces are serial, LocalTalk, and Ethernet. If your computer cannot
use a parallel port for your printer or the location of your printer is
distant from the computer, you can use the serial port, LocalTalk port, or
Ethernet port of the computer to connect your printer. Fujitsu offers the
optional serial interface (RS-232C/422A) board, LocalTalk board, and
Ethernet board C for these purposes.
Notice:
When sharing the printer among multiple computers, setting the I/O
time-out short may cause a printing problem.
Installing an Interface Board
1. To install an interface board,
first make sure the printer is
turned off. Remove the
interface board slot cover
from the back right of the
printer.
Installing an
Interface
Expansion Board
☞
Ethernet interface board Serial interface board
LocalTalk interface board
Remove
the cover