Filter
Top Products
2-6
Using the Stylistic 2300 Pen Tablet
• If the battery pack charge drops to the Low-Battery Warning level while the
system is running, the system will beep periodically. If this occurs, suspend
system operation, shut down the system, or attach an external power source, such
as the AC adapter, to the pen tablet.
• If the battery charge drops to the Critically Low level while the system is running,
the system is forced into Suspend-to-RAM mode. If this occurs, you must either
install a charged battery pack, or connect an appropriate external power source
such as the AC adapter before you can resume system operation. (If the battery
charge drops to the Critically Low level while the system is in Suspend-to-RAM
mode, the system stays in Suspend-to-RAM mode.)
• Suspending system operation interrupts data communications; however, some
programs may block the system from suspending to prevent an interruption.
• The Suspend/Resume button on your system may be disabled. If this is the case,
pressing the Suspend/Resume button may not suspend system operation as
described here. Contact your local help desk or reseller if your system
configuration is not suitable.
• The Suspend/Resume button on your system may be programmed to act as an
On/Off switch. If this is the case, all active data will be lost if this button is
pressed. In order to ensure that all active data is saved prior to turning off the
system, exit Windows by choosing Shut Down from the Start menu and carry out
the Shut Down command; this also turns off the system.
• If your system is equipped with a PC Card that allows you to connect to a wired
or wireless network, you may be logged off the network after a period of
inactivity while system operation is suspended. Contact your network
administrator or local help desk for details on log-off parameters for your
network.
Resuming System Operation 2
To resume system operation, (from either Suspend-to-RAM or Suspend-to-Disk
modes), press the Suspend/Resume button.
• From Suspend-to-RAM mode
After a few seconds, the system returns to the Fully On state and system
operation resumes. Note that the display turns on shortly before the pen becomes
active due to the power-up sequences observed by the system.
• From Suspend-to-Disk mode
Active data is read from the hard disk drive, and after 15 to 30 seconds, the system
returns to the Fully On state.