Filter
Top Products
Using Hotpads
2-7
Note that power to several system components must be restored before system
operation resumes. Allow sufficient time for system operation to resume before
attempting to use the system. If your system uses Suspend-to-Disk mode, it will
take longer to resume operation as compared to using Suspend-to-RAM mode.
Time is needed to read data from the hard disk drive.
• Use the system as you normally would once system operation resumes.
All programs resume at the point where execution stopped when system operation
was suspended.
Using Hotpads 2
Hotpads are pen-active areas below the system display that you can use to change
the display and speaker settings while the system is running. To use a hotpad, tap
directly on it with the pen. You can also press and hold the pen tip against the
Volume, Contrast, and Brightness hotpads to automatically repeat the hotpad
function. The location of each hotpad is shown in Figure 2-1.
Figure 2-1 Hotpads
A summary of each hotpad’s function is given below:
• Programmable hotpad
This hotpad can be programmed for application-specific functions. Contact your
local help desk or reseller if you need assistance using the Programmable hotpad.
• Volume hotpads
These hotpads set the volume of the pen tablet speaker or headphones, if used.
(Note that the internal speaker is disabled when headphones are plugged in.)
• Speaker Mute hotpad
This hotpad turns the pen tablet speaker or headphones on or off. When you tap
this hotpad to turn on the speaker or headphones, the system beeps.
Programmable
Volume
Down
Speaker
Mute
Volume
Up
Display
Select
Fast Slow Slow Fast Down Up
Down
Up
Contrast (certain systems
do not have contrast hotpads)
Brightness