Filter
Top Products
18
Using the Stylistic 3400 Pen Tablet
Shutting Down the System 2
Follow these steps to shut down and turn off your system:
1. If system operation has been suspended, resume system operation. See
“Resuming System Operation” later in this chapter for details.
2. Save your work and close all running programs.
3. Choose Shut Down from the Windows (98, NT Workstation, or 2000) Start menu
and carry out the Shut Down command.
The system is now in the Off state.
Suspending System Operation 2
The Stylistic 3400 pen tablet allows you to suspend the system operation without
closing programs or exiting the operating system. Use this feature to conserve battery
power when a system shutdown is not practical or when the battery needs to be
changed.
To suspend system operation:
1. Press the Suspend/Resume button, or carry out the Standby command from your
operating system or power management program. (If your system is configured
to suspend operation using Save-to-Disk mode, which is explained later in this
procedure, a message is displayed while data is saved to your hard disk.)
The Power icon either flashes (Suspend-to-RAM) or is not displayed
(Save-to-Disk) when system operation is suspended, depending on how your
system is configured. At this point, programs that were running are stopped,
active data is saved, and the system enters one of two different low-power states,
or suspend modes, as explained in the following paragraphs.
2. Observe the Power icon in the Status display to determine which suspend mode
your system is using.
Caution
If you are replacing the battery pack,
wait until system operation is
suspended and the power icon is flashing
before you remove the battery
pack. Failure to do so could result in loss of your unsaved data.