Filter
Top Products
System upgrades
A26361-K990-Z120-1-7619, Edition 6 59
Installing and removing drives
The casing can accommodate a total of seven drives:
● three accessible drives
(two 5¼" drives and one 3½" drive)
● four non-accessible drives
(3½" drives)
"Accessible drives" are e.g. DVD or CD ROM drives, into which a data carrier can be inserted from
outside. Non-accessible drives are e.g. hard disk drives.
Serial ATA drives and SCSI drives
You can install S-ATA drives or SCSI drives/SAS drives (Serial Attached SCSI drives) in your device.
Your device is equipped with corresponding adapter cables. S-ATA drives are supported by default
(refer also to the manual for the mainboard). Mixed equipment is also possible. When simultaneously
installing S-ATA hard disks and SCSI hard disks, you must ensure the proper assignment of the
cables to the corresponding connectors.
i
On the CELSIUS M the connector P11 is located behind the cover of the power supply.
When changing the hard disk equipment, you must remove the cover (see "
Removing
cover of power supply (CELSIUS M)").
For CELSIUS M only:
The internal wiring of your device is shown in the following wiring diagrams.
Wiring diagram for S-ATA drives, SCSI drives or SAS drives (CELSIUS M)
SV
P11
P5
HD 1
DVD
CD ROM
FD
HD 2
HD 3
HD 4
SATA
SCSI
SAS
If you only install S-ATA drives, SCSI drives or SAS drives, connect the hard disk connections to the
connector P11.