Filter
Top Products
6-28 SPARC Enterprise M4000/M5000 Servers Service Manual • August 2009
6.3.6 Removing the Tape Drive Backplane of the
SPARC Enterprise M4000 Server
1. Remove the CD-RW/DVD-RW Drive Backplane.
This step includes removing the CD-RW/DVD-RW Drive Unit and the CD-
RW/DVD-RW Drive Backplane. See “Removing the CD-RW/DVD-RW Drive
Backplane of the SPARC Enterprise M4000 Server” on page 6-17.
2. Remove the tape drive unit from the server and place it on the ESD mat.
See “Removing the Tape Drive Unit” on page 6-25.
3. Remove the power cable (p4) from the tape drive backplane.
4. Disconnect the blue serial cable from the tape drive backplane.
5. Loosen the captive screw that holds the tape drive backplane (TAPEBP) in
place and lift the tape drive backplane (TAPEBP) from the guide pins and
place the backplane on the ESD mat.
6.3.7 Installing the Tape Drive Backplane of the SPARC
Enterprise M4000 Server
1. Place the tape drive backplane (TAPEBP) onto the guide pins.
2. Tighten the captive screw that holds the tape drive backplane (TAPEBP) in
place.
3. Connect the blue serial cable to the tape drive backplane.
4. Connect the power cable (p4) to the tape drive backplane.
Caution – Do not force any components into server slots. Doing so can cause
damage to the component and server.
5. Install the tape drive.
See “Installing the Tape Drive Unit” on page 6-26.
6. Install the CD-RW/DVD-RW Drive Backplane.
This step includes installing the CD-RW/DVD-RW Drive Backplane and the CD-
RW/DVD-RW Drive Unit. See “Installing the CD-RW/DVD-RW Drive Backplane
of the SPARC Enterprise M4000 Server” on page 6-18.