Filter
Top Products
All Rights Reserved, Copyright © FUJITSU LIMITED 2007
14
2.3 Setting Items
ETERNUSmgr User Guide -Introduction- P2X0-0202-01EN
Caution:
• Note that even if the TARGET_TYPE and the TARGET_FLAG settings are different,
ETERNUSmgr operations are not affected.
• Although any character string can be set in TARGET_TYPE, it is recommended to set
one of the correct target device types ("ETERNUS8000", "ETERNUS4000",
"ETERNUS2000", "ETERNUS6000", "ETERNUS3000", "GR710", "GR720", "GR730",
"GR740", "GR820", or "GR840"). The character string in TARGET_TYPE is used
when the administrator is notified by E-mail, and in the alarm history files.
■ Target Flag
Set to either 1, 2 or 4 according to the Target Type being monitored.
[Parameter]
TARGET_FLAG (1, 2 or 4)
1: ETERNUS3000, ETERNUS GR710, GR720, GR730
2: ETERNUS6000, ETERNUS GR740, GR820, GR840
4: ETERNUS8000, ETERNUS4000, ETERNUS2000
[Example]
When the type of target device is ETERNUS3000:
TARGET_FLAG=1
Caution:
• The TARGET_FLAG parameter must be set to the correct Target Type. ETERNUSmgr
will be unable to monitor the target device properly if this setting is wrong.
• Note that even if the TARGET_TYPE and the TARGET_FLAG settings are different,
ETERNUSmgr operations are not affected.
■ Detect Offline Targets
This parameter determines whether or not notification is sent when a device goes offline.
The "Offline" condition is entered when ETERNUSmgr cannot monitor a target device due to a machine
problem (e.g. device is turned off, busy, etc.), or problem with the communication link between the ETER-
NUSmgr server and the target device (e.g. bad connection, timeouts due to network overload).
If this happens, the ETERNUSmgr Top Menu ("menu.htm") will show the target device status as being
"(*Offline*)" in a similar manner to the detection of machine failures, and E-mail notification (if enabled)
will be sent.
ETERNUSmgr does not provide for notification of "Offline" status if this parameter is omitted.
This parameter is enabled in its setup file immediately after installation.
Set "TRUE" to detect the offline status.
Omit setting to disable this parameter.
[Parameter]
DETECT_OFFLINE
[Example]
Detect the offline status, set as below:
DETECT_OFFLINE=TRUE