Filter
Top Products
All Rights Reserved, Copyright © FUJITSU LIMITED 2007
32
3.1 ETERNUSmgr for Solaris OS and Linux
ETERNUSmgr User Guide -Introduction- P2X0-0202-01EN
As explained in "2.1 Setup files" (page 9) ETERNUSmgr treats any file that conforms to the "STX~.INI"
format as a setup file and loads it accordingly. If ETERNUSmgr detects multiple setup files (for multiple
devices), it will load all of them.
ETERNUSmgr automatically reads the setup file(s) at startup. If it fails to locate or read any setup files, the
following message is displayed and startup is terminated.
ETERNUSmgr determines the device that is to be monitored according to the "TARGET_ADDR" param-
eter specified in the setup file and accesses it accordingly. If a "TARGET_ADDR" parameter is not speci-
fied, or if it is incorrect, the following message is displayed and startup is terminated.
Note:
"STXPOLL_1.INI" indicates the name of the setup file in which the error was actually detected.
If ETERNUSmgr detects the "TARGET_ADDR" parameter to be missing, incorrect, or duplicated in mul-
tiple setup files, the following message is displayed and startup is terminated.
Note:
"STXPOLL_1.INI" and "STXPOLL_2.INI" indicate the name of the setup files in which the error
was actually detected.
If any such messages are displayed on the screen when ETERNUSmgr is starting up, check that a setup file
exists and all parameter settings are correct.
In addition, the contents of all the displayed messages are logged in the "stxchk.sts" file stored in the direc-
tory in which ETERNUSmgr is installed (this file will be empty if ETERNUSmgr has started up nor-
mally).
stxchk: ETERNUSmgr could not start.
Error detail: No INI file.
*** stxpoll could not start. ***
stxchk: ETERNUSmgr could not start.
Error detail: Invalid host name was defined at "STXPOLL_1.INI".
Please check "TARGET_ADDR" parameter in this file.
*** stxpoll could not start. ***
stxchk: ETERNUSmgr could not start.
Error detail: Invalid host name were defined at following INI files.
Please check "TARGET_ADDR" parameter in these files.
STXPOLL_1.INI
STXPOLL_2.INI
*** stxpoll could not start. ***