Filter
Top Products
10 SPARC Enterprise T5440 Server Administration Guide • July 2009
■ -script - Does not prompt for confirmation and acts as if yes was specified
■ -source - Specifies the IP address and full path name (URL) to the flash
image
After the flash image has been updated, the system automatically resets, runs
diagnostics, and returns to the login prompt on the serial console.
-> load -source tftp://129.168.10.101/pathname
NOTE: A firmware upgrade will cause the server and ILOM to be reset.
It is recommended that a clean shutdown of the server be done prior
to the upgrade procedure. An upgrade takes about 6 minutes to
complete. ILOM will enter a special mode to load new firmware. No
other tasks can be performed in ILOM until the firmware upgrade it
complete and ILOM is reset.
Are you sure you want to load the specified file (y/n)?y
Do you want to preserve the configuration (y/n)? y
.................................................................
Firmware update is complete.
ILOM will now be restarted with the new firmware.
Update Complete. Reset device to use new image.
->
U-Boot 1.1.1 (May 23 2007 - 21:30:12)
***
POST cpu PASSED
POST ethernet PASSED
Hit any key to stop autoboot: 0
## Booting image at fe080000 ***
IP Protocols: ICMP, UDP, TCP, IGMP
Checking all file systems...
fsck 1.37 (21-Mar-2005)
Setting kernel variable ...
... done.
Mounting local filesystems...
Cleaning /tmp /var/run /var/lock.
Identifying DOC Device Type(G3/G4/H3) ...
OK
Configuring network interfaces....Internet Systems Consortium DHCP
Client V3.0.1
Copyright 2007 Internet Systems Consortium
All rights reserved.
For info, please visit http://www.isc.org/products/DHCP