Filter
Top Products
52 Replacing and Adding System Components
Replacing the power supply
Your power supply can be removed without disconnecting power supply
cables or removing screws.
To replace the power supply:
1 Turn off the computer, disconnect the power cord, modem cord (if
installed), and all external peripheral devices.
2 Remove the right panel. (See “Removing the side panels” on page 19 and
observe the “Static electricity precautions” on page 17.)
3 Pull the power supply release lever away from the chassis. This releases
the power supply from its connector and moves it out from the back of
the chassis.
4 From the rear side of the chassis, pull the power supply out and away
from the chassis.
5 Make sure that the voltage switch on the back of the new power supply
is set to the correct voltage for your area.
Power supply
release lever
Power
supply
05957.book Page 52 Monday, May 8, 2000 10:09 AM