Filter
Top Products
Publication No. GEG-99126 Genicom Aug 01
B-4 GENICOM LN45 and Intelliprint mL450 Installation Guide
Regulatory Compliances
" If debris (metal or liquid) migrates into the machine, switch off and unplug the machine. Contact your
point of purchase. Operating a debris-contaminated machine can cause a fire or shock hazard.
" Never open or remove machine covers that are secured with screws unless specifically instructed in
the "User's Manual."
" A high voltage component can cause a shock hazard.
" Do not try to alter the machine configuration, or modify any parts. An unauthorized modification can
cause smoke or fire.
" Never throw a drum cartridge into an open flame. Toner remaining in the cartridge can cause an
explosion and you can get burnt.
" Do not place a magnet near the safety switch of the machine. A magnet can activate the machine acci-
dentally, resulting in injuries.
" Do not place any heavy object on the machine. An off-balance machine can fall over or the heavy
object can fall, causing injuries.
" Do not use a highly flammable spray near the machine. It can cause a fire.
" Stop operation immediately if your machine produces smoke, excessive heat, unusual noise, or smell,
or if water is spilled into the machine. These conditions can result in a fire. Immediately switch off and
unplug the machine, and contact your point of purchase.
" To prevent a fire or shock hazard, follow the instruction below based on your machine configuration.
If in doubt, contact your point of purchase.
Paper Jam Precautions
" The fuser becomes very hot in operation. If a paper jam has occurred, turn the power off and wait at
least 40 minutes before removing the drum cartridge and touching the fuser section.
" When clearing a jammed paper that is difficult or impossible to see, do not try to remove it by yourself.
Doing so can cause injuries. Contact your point of purchase.
" When removing jammed paper, make sure that no pieces of torn paper are left in the machine. A piece
of paper remaining in the machine can cause a fire.
" If a sheet of paper is not able to be removed or wrapped around the heat roller, do not try to remove
it by yourself. Doing so can cause injuries. Switch off the machine immediately, and contact your point
of purchase.
Regulatory Compliances
Class B Equipment
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to radio com-
munications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
CAUTION: Do not place the machine near heaters or volatile, flammable, or combustible
materials such as curtains that may catch fire.