Filter
Top Products
Terminal Setup
RF Monitor is a very small program and does not even require installation. Just place it in
a directory on your PC and create a shortcut to run it. It will run on all versions of
ows except V3.1 and Windows 95. Wind
1. Move RF Monitor to a Windows PC with Network access to the RF terminal.
2. Run RF Monitor. (Create a shortcut or do a Start/Run.)
3.
From the pull down menu, select File/Select Terminal.
4. Key in the RF terminal IP address and leave the port at 1802.
5. From the pull down menu, select Tools/Set Debug Levels. Set all levels to 9 except
Datastream and SNA.
Supported Equipment Manual
•
January, 2006 2-41