Filter
Top Products
Hop Count The number of hops (routers) to pass through to reach the destination LAN.
dd a Rule Fill in the "Destination LAN IP", "Subnet Mask”, “Default Gateway”, "Hop
ded and then click "Add". This rule
for Static Routing will then be added into the "Static Routing Table" below. If
you find any errors before adding it and want to retype it again, just click "Clear"
and the fields will be cleared.
emove a Rule the "Static Routing Table", select
ou
Interface The interface that goes to the next hop (router).
A
Count" and "Interface" of the rule to be ad
R If you want to remove some routing rules from
the rules you want to remove in the table and then click "Delete Selected". If y
want to remove all the rules from the table, just click the "Delete All" button.
Clicking "Reset" will clear your current selections.
of the screen to save the above configurations. You can now confi
uter (with the advanced settings in place).
ter provides extensive firewall protection by restricting connection parameters, thus lim
Click Apply at the bottom gure other advanced sections
r start using the ro
.5 Firewall
he Broadband rou iting the risk of
acker attacks, and defending against a wide array of common Internet attacks. However, for applications that require
nrestricted access to the Internet, you can configure a specific client/server as a Demilitarized Zone (DMZ).
ote: To enable the Firewall settings select Enable and click Apply.
Figure 2.22
o
2
T
h
u
N
56