Filter
Top Products
96 Appendix B ENWW
Envelopes
Envelope construction
Envelope construction is critical. Envelope fold lines can vary considerably, not only between
manufacturers, but also within a box from the same manufacturer. Successful printing on
envelopes depends upon the quality of the envelopes. When selecting envelopes, consider the
following components:
● Weight: The weight of the envelope paper should not exceed 28 lb (105 g/m
2
), or jamming
might result.
● Construction: Prior to printing, envelopes should lie flat with less than 6 mm (0.25 in.) curl
and should not contain air. Envelopes that trap air may cause problems.
● Condition: Make sure that the envelopes are not wrinkled, nicked, or otherwise damaged.
● Sizes: From 90 x 160 mm (3.5 x 6.3 in.) to 178 x 254 mm (7 x 10 in.).
Envelopes with double-side seams
An envelope with double-side-seam construction has vertical seams at both ends of the envelope
rather than diagonal seams. This style might be more likely to wrinkle. Make sure that the seam
extends all the way to the corner of the envelope as shown in the following illustration:
1 acceptable envelope construction
2 unacceptable envelope construction
Envelopes with adhesive strips or flaps
Envelopes with a peel-off adhesive strip or with more than one flap that folds over to seal must use
adhesives compatible with the heat and pressure in the printer: 200° C (392° F). The extra flaps
and strips might cause wrinkling, creasing, or jams.
Envelope storage
Proper storage of envelopes contributes to good print quality. You should store envelopes flat. If air
is trapped in an envelope, creating an air bubble, the envelope might wrinkle during printing.
1
2