Filter
Top Products
76 Removal and Replacement
C4224-90962
Pod removal
Figure 4-13Removing the stabilizing pods
The pods connected to the bottom of the printer must be removed before the covers of the
printer can be taken off. The end of the pod removal tool marked “L” removes the left pod;
the end of the tool marked “R” removes the right. To release the pods:
1 Insert the pod removal tool into the slot below the corresponding pod, and press firmly.
2 Lift the pods from the frame.
Alternate procedure:
1 Using a small, flat-blade screwdriver, pry the plastic snaps open.
2 Lift the pods from the frame.