HP (Hewlett-Packard) 12C Calculator User Manual


 
140 Section 10: Program Editing
File name: hp 12c pt_user's guide_English_HDPMF123E27 Page: 140 of 275
Printed Date: 2005/8/1 Dimension: 14.8 cm x 21 cm
Keystrokes
(RPN mode)
Display
Ê
006,43, 33, 008
Shows that instruction in program
line 006 has not been changed.
fs
6,250.00
Sets calculator back to Run mode.
(Display shown assumes results
remain from last example in
preceding section.)
:
2
?
6
25.00
Copies tax rate from R
2
into R
6
.
Keystrokes
(ALG mode)
Display
fs
Sets calculator to Program mode.
gi.
006
006,43, 33, 009
Sets calculator to program line
preceding that containing the
instruction to be changed.
:
6
007, 45 6
Keys new instruction into program
line 007, replacing the
:
2
instruction previously there.
Ê
008,43, 33, 010
Shows that instruction in program
line 008 has not been changed.
fs
6,250.00
Sets calculator back to Run mode.
(Display shown assumes results
remain from last example in
preceding section.)
:
2
?
6
25.00
Copies tax rate from R
2
into R
6
.
Adding Instructions at the End of a Program
To add one or more instructions at the end of the last program stored in program
memory:
1. Press fs to set the calculator to Program mode.
2. Press gi. followed by three digits that specify the last line you keyed
into program memory (that is, the highest numbered line, not necessarily the
line most recently keyed in).
3. Key in the new instruction or instructions.