Filter
Top Products
EN
Chapter 2 Printing Tasks
31
Loading Media into Tray 1
Tray 1 (multi-purpose) holds up to 100
sheets of paper or up to 10 envelopes.
1
Open Tray 1 by pulling the front
cover down.
2
Slide out the plastic tray extender. If
the media being loaded is longer
than 229 mm (9 in.), also flip open
the tray extender.
3
Slide the paper width guides slightly
wider than the media.
4
Place media into the tray (short-
edge in, print-side up). The media
should be centered between the
paper width guides and under the
tabs on the paper width guides.
5
Slide the paper width guides inward
until they lightly touch the media
stack on both sides without bending
it. Make sure the media fits under
the tabs on the paper width guides.
Note
Do not add media to Tray 1 while the
printer is printing. This could cause a
paper jam.
For preprinted material, see “Letterhead
or Preprinted Forms Orientation” on
page 42.
1
2
3
4
5