Filter
Top Products
Configuring the Edge Router Engine
3-11
Console and auxiliary port specifications are provided in Table 3-2 and
Table 3-3, respectively.
Mini-DIN connector pinouts are provided in Appendix A.
The Edge Router module is shipped autoconfigured for connection to a
network running NetWare®. If you are not connected to a NetWare network,
you may see the following message:
The IPXNetwork for LocalPath ms_ethernet couldn’t be
learned.
Ignore this message and continue with the appropriate configuration.
Using the Terminal
to Configure the
Edge Router Engine
Edge Router engine documentation is included on the Cisco Systems
CD-ROM that is shipped with the Edge Router module.
Refer to the
Cisco Router Products Configuration and Reference Guide
for
information on configuring parameters for the Edge Router module.
Table 3-2
Console Port Information
Interface
Connector
Transmission
Type
Protocol
RS-232
8-pin mini-DIN
DTE
Asynchronous, 9600, 8-bit data,
1 stop bit, no parity, XON/XOFF
Table 3-3
Auxiliary Port Information
Interface
Connector
Transmission
Type
Protocol
RS-232
8-pin mini-DIN
DTE
Asynchronous or synchronous, 9600,
8-bit data, 1 stop bit, no parity,
XON/XOFF