Filter
Top Products
5-7
IPv6 Management Features
Telnet6 Operation
Viewing the Current Telnet Activity on a Switch
For example, the following figure shows that the switch is running one
outbound, IPv4 session and is being accessed by two inbound sessions.
Figure 5-4. Example of Show Telnet Output with Three Sessions Active
Syntax:
show telnet
This command shows the active incoming and outgoing telnet
sessions on the switch (for both IPv4 and IPv6). Command
output includes the following:
Session: The session number. The switch allows one outbound
session and up to five inbound sessions.
Privilege: Manager or Operator.
From: Console (for outbound sessions) or the source IP address
of the inbound session.
To: The destination of the outbound session, if in use.
ProCurve# show telnet
Telnet Activity
--------------------------------------------------------
Session : 1
Privilege: Manager
From : Console
To : 10.0.10.140
--------------------------------------------------------
Session : 2
Privilege: Manager
From : 2620:0:260:212::2:219
To :
--------------------------------------------------------
Session : ** 3
Privilege: Manager
From : fe80::2:101
To :
The ** in the “Session: indicates the
session through which show telnet was
run.