Filter
Top Products
5-8
IPv6 Management Features
Telnet6 Operation
Enabling or Disabling Inbound Telnet6 Access
For example, to disable Telnet6 access to the switch, you would use this com-
mand:
ProCurve(config)# no telnet6-server
Viewing the Current Inbound Telnet6 Configuration
Figure 5-5. Show Console Output Showing Default Console Configuration
Syntax:
[ no ] telnet6-server
This command is used at the global config level to enable (the
default) or disable inbound Telnet6 access to the switch.
The no form of the command disables inbound telnet6.
Note: To disable inbound Telnet access completely, you
must disable Telnet access for both IPv6 and IPv4. (The
command for disabling Telnet4 access is no telnet-server.)
Syntax:
show console
This command shows the current configuration of IPv4 and
IPv6 inbound telnet permissions, as well as other informa-
tion. For both protocols, the default setting allows inbound
sessions.
LPE-5400-a100(config)# show console
Console/Serial Link
Inbound Telnet Enabled [Yes] : Yes
Inbound Telnet6 Enabled [Yes] : Yes
Web Agent Enabled [Yes] : Yes
Terminal Type [VT100] : VT100
Screen Refresh Interval (sec) [3] : 3
Displayed Events [All] : All
Baud Rate [Speed Sense] : speed-sense
Flow Control [XON/XOFF] : XON/XOFF
Session Inactivity Time (min) [0] : 0
Telnet6 Setting