Filter
Top Products
5-12
IPv6 Management Features
SNTP and Timep
For example, the show sntp output for the preceeding sntp server command
example would appear as follows:
Figure 5-6. Example of Show SNTP Output with Both an IPv6 and an IPv4 Server Address Configured
Note that the show management command can also be used to display SNTP
server information.
Configuring (Enabling or Disabling) the Timep Mode
Software release K.13.01 enables configuration of a global unicast address for
IPv6 Timep time server.
This section lists the Timep and related commands, including an example of
using an IPv6 address. For the details of configuring Timep on the switch, refer
to the chapter titled “Time Protocols” in the Management and Configuration
Guide for your switch.
The following commands are available at the global config level for Timep
operation.
ProCurve(config)# show sntp
SNTP Configuration
Time Sync Mode: Sntp
SNTP Mode : Broadcast
Poll Interval (sec) [720] : 719
Priority SNTP Server Address Protocol Version
-------- ---------------------------------------------- ----------------
1 2001:db8::215:60ff:fe79:8980 7
2 10.255.5.24 3
This example illustrates the
command output when both
IPv6 and IPv4 server
addresses are configured.
Commands Affecting Timep Function
show timep Display the current timep configuration.
timesync < sntp | timep > Enable either SNTP or Timep as the time
synchronization method on the switch without
affecting the configuration of either.
ip timep dhcp [ interval
< 1 - 9999 >]
Enable Timep operation with a Timep server
assignment configured from an IPv4 or IPv6 DHCP
server. Optionally change the interval between time
requests.