Filter
Top Products
4-9
IPv6 Addressing Configuration
Enabling DHCPv6
Enabling DHCPv6
Enabling the DHCPv6 option on a VLAN allows the switch to obtain a global
unicast address and an NTP (network time protocol) server assignment for a
Timep server. (If a DHCPv6 server is not needed to provide a global unicast
address to a switch interface, the server can still be configured to provide the
NTP server assignment. This is sometimes referred to as “stateless DHCPv6”.)
Syntax: [no] ipv6 address dhcp full [rapid-commit]
This option configures DHCPv6 on a VLAN, which initiates
transmission of DHCPv6 requests for service. If IPv6 is not
already enabled on the VLAN by the ipv6 enable command, this
option also enables IPv6 and causes the switch to autocon-
figure a link-local unicast address with an EUI-64 interface
identifier.
Notes: A DHCPv6 server does not assign link-local
addresses, and enabling DHCPv6 on a VLAN does not
affect a pre-existing link-local address configured on the
VLAN.
A DHCPv6-assigned address can be configured on a VLAN
when the following is true:
• The assigned address is not on the same subnet as a
previously configured autoconfig address.
• The maximum IPv6 address limit on the VLAN or the
switch has not been reached.
If a DHCPv6 server responds with an IPv6 address assign-
ment, this address is assigned to the VLAN. (The DHCPv6-
assigned address will be dropped if it has the same subnet as
another address already assigned to the VLAN by an earlier
autoconfig command.)
— Continued on the next page. —