Filter
Top Products
5-9
IPv6 Management Features
SNTP and Timep
SNTP and Timep
Configuring (Enabling or Disabling) the SNTP Mode
Software release K.13.01 enables configuration of a global unicast address for
IPv6 SNTP time server.
This section lists the SNTP and related commands, including an example of
using an IPv6 address. For the details of configuring SNTP on the switch, refer
to the chapter titled “Time Protocols” in the Management and Configuration
Guide for your switch.
The following commands are available at the global config level for SNTP
operation.
Commands Affecting SNTP Function
show sntp Display the current SNTP configuration.
timesync < sntp | timep > Enable either SNTP or Timep as the time
synchronization method on the switch without
affecting the configuration of either.
[no] timesync Enable time synchronization. (Requires a timesync
method to also be enabled.) The no version disable
time synchronization without affecting the
configuration of the current time synchronization
method.)
[ no ]sntp Enables SNTP with the current SNTP configuration.
The no version disables SNTP without changing the
current SNTP configuration.
sntp < unicast | broadcast > Configures the SNTP mode. (Default: Broadcast)
sntp < 30 - 720 > Changes the interval between time requests.
(Default: 720 seconds)