Filter
Top Products
4. Locate the memory module sockets on the system board.
WARNING! To reduce risk of personal injury from hot surfaces, allow the internal system
components to cool before touching.
5. Open both latches of the memory module socket (1), and insert the memory module into the
socket (2).
NOTE: Populate the DIMM sockets in the following order: DIMM1, DIMM3, DIMM2, then
DIMM4.
Figure 7-6 Installing a DIMM
NOTE: A memory module can be installed in only one way. Match the notch on the module
with the tab on the memory socket.
A DIMM must occupy the XMM1 socket. Always populate the white sockets before the black
sockets in each channel.
In order to create a dual-channel memory configuration, the memory capacity of Channel A must
equal the memory capacity of Channel B.
6. Push the DIMM module down firmly into the socket, ensuring that the module is fully inserted
and properly seated. The DIMM must be pushed all the way down into the socket and sit evenly
in the socket to avoid memory corruption. Make sure the latches are in the closed position (3).
7. Repeat steps 5 and 6 to install any additional modules.
92 Chapter 7 Removal and Replacement Procedures Small Form Factor (SFF) Chassis