Filter
Top Products
System Board
1. Prepare the computer for disassembly (Preparation for Disassembly on page 84).
2. Remove the access panel (
Access Panel on page 85).
3. Remove the front bezel (
Front Bezel on page 86).
4. Loosen the plastic cable fasteners (
Plastic Wire/Cable Fastener and Clips on page 117).
5. Remove all PCI and PCI Express expansion boards (
Removing or Installing an Expansion Card
on page 94).
6. Remove all memory modules (
Memory on page 88).
7. Disconnect all data and power cables from the system board.
8. Remove the heatsink (
Heatsink on page 121).
9. Remove the power supply (
Power Supply on page 123).
10. Remove the eight screws that secure the system board to the chassis, slide the board about
1.25 cm (1/2 inch) toward the front of the chassis, and then lift the board out of the chassis.
NOTE: HP Pro 3015 shown. System board appearance varies by model.
To install the system board, reverse the removal procedure.
System Board 125