Filter
Top Products
9. Push in the latch holding the drive cage upright (1) and lower the drive cage all the way down
(2).
Figure 7-32 Lowering the Drive Cage
10. Connect the appropriate drive cables:
a. If installing a diskette drive (available on some models only), connect the power and data
cables to the rear of the drive and connect the other end of the data cable to the connector
on the system board.
b. If installing a media card reader, connect the USB cable from the media card reader to the
USB connector on the system board.
11. Replace the front bezel and access panel.
12. Reconnect the power cord and turn on the computer.
13. Lock any security devices that were disengaged when the access panel was removed.
112 Chapter 7 Removal and Replacement Procedures Small Form Factor (SFF) Chassis