Filter
Top Products
C Additional fax setup
After completing all the steps in the getting started guide, use the instructions in this section to
complete your fax setup. Keep your getting started guide for later use.
In this section, you will learn how to set up the device so that faxing works successfully with
equipment and services you might already have on the same phone line.
TIP: You can also use the Fax Setup Wizard (Windows) or HP Setup Assistant (Mac OS X) to
help you quickly set up some important fax settings such as the answer mode and fax header
information. You can access these tools through the software you installed with the device. After
you run these tools, follow the procedures in this section to complete your fax setup.
This section contains the following topics:
•
Set up faxing (parallel phone systems)
• Serial-type fax setup
•
Test fax setup
Set up faxing (parallel phone systems)
Before you begin setting up the device for faxing, determine which kind of phone system your
country/region uses. The instructions for fax setup differ depending on whether you have a serial-
or parallel-type phone system.
• If you do not see your country/region listed in the table below, you probably have a serial-type
phone system. In a serial-type phone system, the connector type on your shared telephone
equipment (modems, phones, and answering machines) does not allow a physical connection
to the "2-EXT" port on the device. Instead, all equipment must be connected at the telephone
wall jack.
NOTE: In some countries/regions that use serial-type phone systems, the phone cord that
came with the device might have an additional wall plug attached to it. This enables you to
connect other telecom devices to the wall jack where you plug in the device.
You might need to connect the supplied phone cord to the adapter provided for your country/
region.
• If your country/region is listed in the table below, you probably have a parallel-type telephone
system. In a parallel-type phone system, you are able to connect shared telephone equipment
to the phone line by using the "2-EXT" port on the back of the device.
NOTE: If you have a parallel-type phone system, HP recommends you use the 2-wire
phone cord supplied with the device to connect it to the telephone wall jack.
Table C-1 Countries/regions with a parallel-type phone system
Argentina
Australia Brazil
Canada Chile China
Colombia Greece India
Indonesia Ireland Japan
Korea Latin America Malaysia
Mexico Philippines Poland
174 Additional fax setup