Filter
Top Products
Service Calibrations
5-35
HP DesignJet 5000 Series Printers Service Manual
Calibration Error: 3130
Problem
Description:
Firmware Error.
Corrective Action: Try the following:
n Power the Printer OFF and ON again using the Power Switch at
the back of the Printer to reset the memory.
n Upgrade the Firmware ⇒ Page 9-12.
Calibration Error: 3200
Problem
Description:
Error while scanning calibration pattern. It is also possible that
when it calibrates the Line Sensor, the Carriage positions itself
directly over one of the black arrows of the calibration pattern. If
this happens, the Printer thinks it has black or colored media loaded
and the calibration fails.
Corrective Action: Try the following:
n Check that the media used for the calibration is white.
n If the media used is too dark, try the calibration with white media.
If the error persists, replace Lens Cover Assembly ⇒ Page 9-5.
n If the Carriage positions itself directly over the black arrow, try
loading the media a few milimeters to the right or left of the blue
line on the Platen - this should be enough to prevent the error.
Alternatively, paint the black arrows with white correction fluid
or stick a white label on top of the arrows.
n Replace the Carriage Assembly ⇒ Page 8-46.
Calibration Error: 4000 (Service)
NOTE This code is not an error. See the other codes reported.
Calibration Error: 4001 (Service)
Problem
Description:
Firmware error.
Corrective Action: Try the following:
n Power the Printer OFF and ON again using the Power Switch at
the back of the Printer and retry the calibration.
n Download the latest Firmware ⇒ Page 9-12.