Filter
Top Products
Chapter 9 Troubleshooting and FAQs
40
•
At 100 Mbps, connect to a 100BASE-TX hub/switch (not
100BASE-T4).
•
For NetWare, make sure you specify the correct frame type in
your NET.CFG file.
•
Make sure the duplex mode setting on the adapter matches
the setting on the switch.
The adapter stopped working without apparent cause.
•
Run the diagnostics.
•
Try reseating the adapter in its slot, or try a different slot if
necessary.
•
The network driver files may be corrupt or missing. Remove
the drivers and then reinstall them.
The Wake on LAN feature is not working.
•
Make sure the WOL cable is attached and that power is being
applied to the computer.
•
Check the BIOS for its WOL setting. Some computers may
need to be configured for WOL.
•
Make sure the network cable is fully attached to the adapter.