Filter
Top Products
Chapter 10 Technical Information
43
2. Click the Adapters tab.
3. Under the “Network Adapters” field, highlight the adapter
you’re removing and click the Remove button.
4. Click OK.
5. Follow the instructions in the section Installing the
Adapter in the NetServer at the start of this manual.
Fast Ethernet Wiring
The 100BASE-TX specification supports 100 Mbps
transmission over two pairs of Category 5 twisted-pair Ethernet
(TPE) wiring. One pair is used for transmit and the other for
receive. Segment lengths are limited to 100 meters with
100BASE-TX for signal timing reasons. This complies with the
EIA 568 wiring standard.
Power Management
The selections are ACPI and APM. ACPI should work in most
computers.
The APM selection will pre-enable the Wake-on-LAN function
of the adapter. Set this selection to APM if one of the following
apply:
1. You are having difficulty with remote wake-up in
computers that are compliant with the PCI 2.2
specification. You are running an OS that is not ACPI
(Advanced Control and Power Interface) aware and you are
not using the 3-pin header cable.
2. You are running an ACPI aware OS (such as Windows 98)
on a non-ACPI computer and the link light goes out when
you shut down the system, disabling Wake-on-LAN.