Filter
Top Products
Chapter 10 Technical Information
42
your PCI BIOS Setup program.
Here are some examples of PCI BIOS setup program
parameters:
PCI slot #:
Slot where the adapter is installed
Master: ENABLED
Slave: ENABLED
Latency timer: 40
Interrupt:
Choose an IRQ from the list
Edge-level: Level
The exact wording of these parameters varies with different
servers.
Removing an Existing Adapter in
Windows 2000
If you are replacing an existing adapter with a HP NetServer
10/100 adapter, follow these steps before physically removing
the adapter card:
1. Double-click My Computer.
2. Double-click Control Panel.
3. Double-click System.
4. Click the Hardware tab.
5. Click the Device Manager button.
6. Double-click Network Adapters.
7. Right-click on the listing for the adapter you want to
remove and click Uninstall.
8. Click OK.
9. Follow the instructions in the section Installing the
Adapter in the NetServer at the start of this manual.
Removing an Existing Adapter in
Windows NT
1. From the Control Panel, double-click the Network icon.