Filter
Top Products
Removal and replacement procedures 37
3.
Slide the cover toward the rear of the server and then lift the top cover to remove it from the
chassis. Lift the top cover away from the chassis.
Figure 1 Removing the Top Cover
To reinstall the top cover:
1. Align the top cover to the chassis and then slide it towards the front panel to position it into
place.
2. Once the cover is attached to the chassis, tighten the screw on the top cover with a T-10 wrench.
Figure 2 Reinstalling the Top Cover
Drives
The server supports the following configurations:
• 2 drive bays for 3.5-inch hard disk drives and 1 drive bay for an optical disc drive
• 4 drive bays for 3.5-inch hard disk drives and 1 drive bay for an optical disc drive.