Filter
Top Products
Printer Software Information
Before you can use your printer with any software programs, you must
first install the printer’s software. Your printer’s software includes two
printer drivers that support both Windows® 3.1
x
and Windows 95. The
printer’s software will automatically select the optimal printer driver
based on the requirements listed below.
Minimum System Requirements
PCL Driver Host-Based Driver
•386 processor •486 processor
•4 MB RAM (Windows 3.1
x
)or
16 MB RAM (Windows 95)
•8 MB RAM (Windows 3.1
x
)or
16 MB RAM (Windows 95)
•5 MB free disk space •10 MB free disk space
•DOS 5.0
•Bidirectional communication
Installation Considerations
Some devices (such as a switchbox, zip drive, or software key)
connected between the printer and the computer may prevent the
printer from sending data back to the computer. If you are using one of
these devices, some of your printer’s features will not be available to
you, such as the status window.
During installation, if you get the message “HP LaserJet 6L printer has
not been found,” check the following:
• Check the power cord connections and power source.
• Make sure you are using a high-quality IEEE-1284 compliant parallel
cable.
• Ensure that any devices connected between the printer and the
computer (such as a switch box or zip drive) have bidirectional
capabilities.
If, after checking the items listed above, you still see the
“HP LaserJet 6L printer has not been found” message, click Continue to
proceed with the PCL driver installation.
If the installation could not be successfully completed, see the
Alternative Installation instructions later in this chapter.
1-6 Set Up EN